AIRCHARGER INSTALLATION INSTRUCTIONS This Kit Was Not Designed To Fit Vehicles With A Body Lift.

AIRCHARGER INSTALLATION INSTRUCTIONS This Kit Was Not Designed To Fit Vehicles With A Body Lift. is a pdf Books Car/Motorcylce Owners manual all User document guide that has been posted to category Car Owners. We try to help you provide information about AIRCHARGER INSTALLATION INSTRUCTIONS This Kit Was Not Designed To Fit Vehicles With A Body Lift.. You can read the summary of AIRCHARGER INSTALLATION INSTRUCTIONS This Kit Was Not Designed To Fit Vehicles With A Body Lift. before you save or download full the pdf Books Car/Motorcylce Owners manual all User guide file. I hope you can solve your Car/Motorcylce problem with this Car Owners. Here is the overview of AIRCHARGER INSTALLATION INSTRUCTIONS This Kit Was Not Designed To Fit Vehicles With A Body Lift. :

AIRCHARGER INSTALLATION INSTRUCTIONS This Kit Was Not Designed To Fit Vehicles With A Body Lift. :

TO START: Flat Blade Screwdriver Phillips Screwdriver Ratchet Extension 10mm Socket 10mm Wrench 2.5mm Allen 4mm allen Pliers 1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable. 2. Remove the two bolts that secure the throttle body cover. Then remove the throttle body cover. 3. Disconnect the mass air sensor electrical connection, then release wire loom from airbox. 4. Remove the two vent lines from the air intake resonator as shown. 5. Loosen the hose clamps at the throttle body and airbox, then remove the intake tube from vehicle. 6. Release two airbox lid retainer clips that secure airbox lid to airbox, then remove airbox lid and air filter. Note: On four wheel drive vehicles, it will be necessary to un-hook differential vent hose from airbox lid. 7. Remove the airbox mounting bolt with 10mm socket. 8. Pull firmly up on airbox to release from mounting studs, then remove airbox from vehicles. NOTE: K&N recommends that customers do not discard factory air intake. 9. Remove the airbox mounting stud shown with 10mm wrench. 10. Install “L” bracket (#070066) onto the K&N heat shield as shown. 11. Install “L” bracket (07190) onto the K&N heat shield as shown. 12. Install the edge trim onto the heat shield as shown. Trim as needed. 13. Using a screw driver, push the center of the plastic inner fender retaining clip through, then remove clip from inner fender. 14. Install the heat shield onto the vehicle and secure with the provided hardware. Note: On four wheel drive vehicles, insert differential vent retaining clip into hole provided in heat shield. 15. Assemble the saddle bracket assembly with the provided hardware as shown. 16. Remove ground wire attaching bolt on top of engine cam cover with 10mm wrench.

If you find this pdf Books Car/Motorcylce Owners manual all User guide about AIRCHARGER INSTALLATION INSTRUCTIONS This Kit Was Not Designed To Fit Vehicles With A Body Lift. is useful to solve your Car/Motorcylce problem, you can download this full Books Car/Motorcylce Owners manual all User pdf file and save to your computer/laptop. If you do not find solution after reading the summary of AIRCHARGER INSTALLATION INSTRUCTIONS This Kit Was Not Designed To Fit Vehicles With A Body Lift., you can find others Car Owners or others Books Car/Motorcylce Owners manual all User on the right sidebar. Please click the download button below :

Popular Manuals

Latest Manuals

Related PDF Manuals